LatestNew

FMVSS108 LIGHTING EQUIPMENT LOCATION REQUIREMENTS for TRUCKS, BUSES and MPVs

Aug 26.2020

IMPORTANT NOTE: Every lamp, reflex reflector, and conspicuity treatment must be permanently attached in the location specified below and must comply

with all applicable requirements prescribed for it by FMVSS/CMVSS 108. The face of any device on the front/rear and sides should be, respectively perpendicular

and parallel to the vehicle’s centerline, unless it is photometrically certified at installation angle. No part of the vehicle shall prevent any device from meeting its

prescribed requirements unless an auxiliary device meeting all prescribed requirements is installed.

IN CANADA: Manufacturers and importers of vehicles must have the proper certification test records demonstrating compliance of lighting components

with all prescribed requirements.

 

BASIC EQUIPMENT REQUIRED ON ALL TRUCKS, BUSES & MPVs

 

 

 

ADDITIONAL EQUIPMENT FOR SPECIFIC VEHICLES

VEHICLES 9.1m (30 ft.) LONG OR LONGER

 

 

 

Truck Tractors

 

 

The above tables are summarized from FEDERAL LIGHTING REQUIREMENTS FOR TRUCKS, BUSES, MPVS AND TRAILERS of Federal/Canada Motor Vehicle Safety Standard 108. For more and complete requirement please check out the website of National Highway Traffic Safety Administration of Canada. https://www.nhtsa.gov/